|
Post by moriarty on Sept 27, 2017 21:10:51 GMT
Hello everyone, I am trying to communicate the hmi levi 700E-N through the ethernet port with plc siemens s7-200 using the ethernet module cp 243i and I am not successful . In the protocol configuration on the screen hmi use s7-200 with cp243. By Microwin (software siemens plc) I communicate perfectly with the plc through the network, but with the hmi screen does not communicate. Local Tsap: 10.01 Remote tsap: 10.00 ip plc: 192.168.0.20 ip hmi: 192.168.0.20 gate link: 192.168.0.10 Can some fellow guide me, or send some example. Thank you very much. A greeting .
|
|
|
Post by WECON Support on Oct 9, 2017 3:46:01 GMT
the ip of plc and hmi are the same? the ip address setting of hmi and plc in leviu is in different places, plz check carefully.
|
|
|
Post by moriarty on Oct 10, 2017 11:37:56 GMT
Hola pein
|
|
|
Post by moriarty on Oct 10, 2017 11:40:18 GMT
.Attachments:
|
|
|
Post by moriarty on Oct 10, 2017 17:01:21 GMT
very good, I am attaching photos of the ip configurations of each device and tsap so that you can observe them, if you see something that is not right. I am using Straight Ethernet cable (not crossed).
Thanks and regards
|
|
|
Post by WECON Support on Oct 11, 2017 8:06:15 GMT
the ip of plc 192.168.0.20 in hmi project and plc project, that is ok. But the hmi ip in the hmi project is also 192.168.0.20, that is wrong. Try set it as 192.168.0.11
|
|
lam
New Member
Posts: 1
|
Post by lam on Jul 16, 2021 11:48:33 GMT
How to connect PLC s7-200 cpu 224 with HMI wecon PI8104 ? Please help me! Thanks a lot!
|
|